Prediction of ingress through turbine rim seals part 1:externally-induced ingress
Owen, J. M., Zhou, K., Wilson, M., Pountney, O. and Lock, G., 2010. Prediction of ingress through turbine rim seals part 1:externally-induced ingress. In: ASME Turbo Expo 2010: Power for Land, Sea, and Air, GT 2010, June 14, 2010 - June 18, 2010, 2010-01-01, Glasgow. American Society of Mechanical Engineers, pp. 1217-1234. (Proceedings of the ASME Turbo Expo)
Related documents:This repository does not currently have the full-text of this item.
You may be able to access a copy if URLs are provided below. (Contact Author)
Rotationally-induced (RI) ingress is caused by the negative pressure (relative to the external air) inside the wheelspace of a gas turbine; this negative pressure, which is created by the rotating flow in the wheel-space, drives the ingestion of hot gas through the rim seals. Externally-induced (EI) ingress is caused by the circumferential distribution of pressure created by the blades and vanes in the turbine annulus: ingress occurs in those regions where the external pressure is higher than that in the wheel-space, and egress occurs where it is lower. Although EI ingress is the dominant mechanism for hotgas ingestion in engines, there are some conditions in which RI ingress has an influence: this is referred to as combined ingress (CI). In Part 1 of this two-part paper, values of the sealing effectiveness (obtained using the incompressible orifice equations developed for EI ingress in an earlier paper) are compared with published experimental data and with results obtained using 3D steady compressible CFD (Computational Fluid Dynamics). Acceptable limits of the incompressible-flow assumption are quantified for the orifice model; for the CFD, even though the Mach number in the annulus reaches approximately 0.65, it is shown that the incompressible orifice equations are still valid. The results confirm that EI ingress is caused predominantly by the magnitude of the peak-to-trough circumferential difference of pressure in the annulus; the shape of the pressure distribution is of secondary importance for the prediction of ingress. A simple equation, derived from the orifice model, provides a very good correlation of the computed values of effectiveness. Using this correlation, it is possible to estimate the minimum sealing flow rate to prevent ingress without the need to know anything about the pressure distribution in the annulus; this makes the orifice model a powerful tool for rim-seal design.
|Item Type||Conference or Workshop Items (UNSPECIFIED)|
|Creators||Owen, J. M., Zhou, K., Wilson, M., Pountney, O. and Lock, G.|
|Departments||Faculty of Engineering & Design > Mechanical Engineering|
|Research Centres||Aerospace Engineering Research Centre|
|Additional Information||ASME Turbo Expo 2010: Power for Land, Sea, and Air, GT 2010, 14-18 June 2010, Glasgow, United Kingdom|
Actions (login required)