Research

The effect of mechanical processing on surface stability of pharmaceutical powders: Visualization by atomic force microscopy


Reference:

Begat, P., Young, P. M., Edge, S., Kaerger, J. S. and Price, R., 2003. The effect of mechanical processing on surface stability of pharmaceutical powders: Visualization by atomic force microscopy. Journal of Pharmaceutical Sciences, 92 (3), pp. 611-620.

Related documents:

This repository does not currently have the full-text of this item.
You may be able to access a copy if URLs are provided below.

Abstract

Atomic force microscopy was used to investigate the influence of mechanical processing (milling) on the surface stability of salbutamol sulfate. Phase imaging, a development of tapping mode(TM) atomic force microscopy, was used to elucidate variations in the physico-mechanical properties on the surface of salbutamol sulfate crystals by measuring the phase lag of an oscillating tip in contact with the surface. Simultaneous measurements of topographical and phase images indicated an increase in disorder on the surface as milling time was increased. Specific regions oil the milled samples, independent of topography, showed large variations in phase shift (>30degrees). These regions (not observed on the crystalline salbutamol sulfate) suggested large differences in the physical properties on the surface. It is therefore reasonable to conclude that these regions were likely attributed to mechanically induced amorphous domains. (C) 2003 Wiley-Liss, Inc. and the American Pharmaceutical Association J Pharm Sci 92:611-620, 2003.

Details

Item Type Articles
CreatorsBegat, P., Young, P. M., Edge, S., Kaerger, J. S. and Price, R.
DOI10.1002/jps.10320
DepartmentsFaculty of Science > Pharmacy & Pharmacology
RefereedYes
StatusPublished
ID Code8293
Additional InformationID number: ISI:000181328200016

Export

Actions (login required)

View Item